Brazil 16-Panel Tile Roof PV Mounting Case
An engineering record for a 2 × 8 module layout using four horizontal rail lines and adjustable tile-roof hooks. The drawing and quotation provide the dimensions and component quantities summarized below.
Documented Layout at a Glance
The available project drawing is dated 15 May 2019. The values below are presented as historical project data, not as universal design limits for other roofs.
How the 2 × 8 Layout Maps to the Mounting Hardware
The drawing shows two module rows with two support rails per row. That produces four horizontal rail runs across the array and explains the rail, splice and clamp quantities in the quotation.
Quoted mounting components
| Component | Quantity |
|---|---|
| AL6005-T5 rail, 4,200 mm | 8 pcs |
| Rail splice, 200 mm | 4 pcs |
| Mid clamp for 40 mm module frame | 28 pcs |
| End clamp for 40 mm module frame | 8 pcs |
| SUS304 roof hook | 36 pcs |
Roof Structure to Module Frame
The documented concept is a conventional rail-based tile-roof assembly: the roof attachment connects to a verified structural support, rails create the module support plane, and clamps secure the framed modules.
Confirm the roof build-up
Tile profile alone is not enough. A new project should confirm the structural fixing location, tile clearance, roof condition and the required waterproofing detail before selecting an attachment.
Match the module to the rail layout
Module dimensions, frame thickness and the module manufacturer’s approved clamp zones determine where the rails and clamps can be placed.
Recalculate for the actual site
Attachment spacing, rail span and fastener selection should be checked using the project location, roof geometry, supporting structure and applicable design requirements.
Values Recorded in the Quotation
These figures describe the archived quotation associated with this case. They should not be reused as current product ratings or as design values for another project without engineering verification.
| Record item | Documented value | Interpretation for this page |
|---|---|---|
| Project location | Brazil | Identifies the case-study location only. |
| Roof interface | Tile roof with adjustable roof hooks shown in the drawing | The illustrated attachment concept is a roof-hook-and-rail system. |
| Wind input | Up to 60 m/s in the quotation | A historical quotation input; not a blanket rating for every roof or layout. |
| Snow input | 1.4 kN/m² in the quotation | A historical quotation input that requires project-specific verification before reuse. |
| Main materials | AL6005-T5 aluminum and SUS304 stainless steel | Materials recorded for the rails and mounting hardware in this package. |
Planning a Tile-Roof PV Mounting Layout?
Send the module datasheet, tile profile, roof-structure information, proposed array layout, project location and design-load requirements. Those inputs are needed to select the attachment, rail layout and component quantities for a new project.